Robotics Kits

Robot Kits

Fun to Build, Operating Robot Kits

1 | 2

Submarine Motor With Boat

Suitable for Ages 10 and Older
Use the rudder for changing direction. Attaches via a suction cup to the bottom of the boat to provide motorization. The nose of the motor case turns for on/off position. Detailed instructions with illustrations.
REQUIRES: Assembly . 1 "AA" Battery. Hobby Knife
Boat Length: 6-3/4" (17.1cm) Boat Width: 2-1/4" (5.7cm) Motor Case Length: 4-1/4" (10.8cm)

TAMX0154 - $12.50

Walking Mechanical Giraffe Kit

Suitable for Ages 10 and Older
Everything you need is included...even the motor! The gearbox and switch parts are clear. Low gear ration (203.7:1) has been adopted. The giraffe's graceful walking is created by transforming motor revolution into reciprocationg motion via cranks nad linkage rods. Soft foam "boots" are used on the legs to keep from damaging floors as the giraffe walks. Transparent yellow plastic body parts. Screw-together assembly (screwdriver included)...no glue required. Illustrated assembly instructions.
REQUIRES: Assembly. Hobby Knife. One "AA" Cell Battery

TAMX1105 - $16.95

Crawling Mechanical Turtle Kit

Suitable for Ages 10 and Older
Everything you need is included...even the motor! The gearbox and switch parts are clear. Gear ratio, 58.2:1 has been adopted. Tail movement when turtle crawls. The Turtle's crawling is created by transforming motor revolution into reciprocationg motion via cranks and linkage rods. Soft foam "boots" are used on the legs to keep from damaging floors as the turtle crawls. Transparent green plastic body parts. Screw-together assembly (screwdriver included)...no glue required. Illustrated assembly instructions.
REQUIRES: Assembly. Hobby Knife. One "AA" Cell Battery

TAMX1106 - $16.95

Hopping Mechanical Kangaroo Kit

Suitable for Ages 10 and Older
This amazing kangaroo-robot jumps by moving its rear legs simultan- eously to go forward. When walking slowly, it also uses its front legs, and when running quickly it uses its tail for balance. Everything you need is included! Body parts are transparent orange plastic. When using high-speed gearbox, the kangaroo walks standing on its rear legs and tail. Low-speed gearbox makes the kangaroo walk using its front and rear legs. Simple assembly with screws and snap-lock parts. Altering tail position makes the kangaroo change direction. Includes gearboxes and motor. A small screwdriver is included. Pictorial assembly instructions.
REQUIRES: Assembly. Hobby Knife. One "AA" Cell Battery
Length: 7.1" (18.0cm). Continuous Running Time: 1-3 hours

TAMX1102 - $16.95

Walking Mechanical Dog Kit

Suitable for Ages 10 and Older
This robot dog walks by transferring motor revolution to reciprocat- ing motion via crank and linkage rod. By changing configuration of the gearbox and crank holes, eight types of running speeds can be selected. Leg and body parts are transparent yellow plastic. Coil spring tail wags when the model walks. Gripping parts at the end of each leg to change position according to speed for smooth movement. Simple assembly with screws and snap-lock parts. Includes gearbox and motor. A small screwdriver and hex wrench are included. Pictorial assembly instructions.
REQUIRES: Assembly. Hobby Knife. One "AA" Cell Battery
SPECS: Length: 6.5" (16.5cm). Continuous Running Time: 1-2 hours

TAMX1101 - $16.95

Remote Control Bulldozer Kit

For very experienced model builders.
2 channel remote control unit. Assemble the control box and the bulldozer. Detailed, realistic and motor driven. Remote control performs the following commands: -Forward -Right and left forward turns -Right and left pivot turns -Right and left reverse turns -Reverse 8T, 42T, 38T and 12T pinion gears. Pre-cut wooden chassis. Realistically molded rubber tracks. Detailed pictorial assembly instructions.
REQUIRES: Assembly. Two UM-2 or UM-3 Dry Cell Batteries. Large Phillips Screwdriver. Modeling Knife. Hammer.
SPECS: Width: 5-3/8" (13.6cm)

TAMX7090 - $35.95

Wall-Hugging Mouse Kit

For very experienced model builders.
Configured to represent a mouse moving along a wall. Powered by two electric motors. Using a micro switch and a feeler whisker to start or stop power to the motors, the mouse will always keep hugging the wall. Preassembled gearbox uses a worm gear for power and long life. Vacuum formed mouse body and sturdy chassis are made from tough plastic. Detailed pictorial instructions
REQUIRES: Assembly. Two AA Alkaline Batteries. Hammer. Side Cutter. Phillips Screwdriver. Awl. Hobby Knife

TAMX7068 - $19.95

Remote Control Construction Robot Kit

Suitable for Ages 12 & Older
Use your imagination and create a remote control robot that will perform various actions such as grabbing, scooping up, lifting, carrying, and more! Construct an arm type robot that can grab onto an object, lift it, then let it go. Or construct a shovel type robot where the crank arm moves the shovel to scoop up, lift, and drop multiple objects at one time. Or construct a bucket type where the crank revolution is transformed into bucket opening/closing actions via the combination of long arms. Your imagination is the limit! Clear smoke colored remote control box has 4 channels and enables control of 4 different movements by adding separately available gearboxes. Twin-motor gearbox. 4-speed type, crank axle gearbox. Universal arms (170mm), plate (160x60mm), and 3mm push rivets (10mm & 8mm length). Ball caster and tires. Add separately available adhesive material to the robot's grips allows it to handle round objects. Detailed assembly guide.
REQUIRES: Assembly. 2 D Batteries. Hobby Knife

TAMX7062 - $52.95

Remote Control Mechanical Insect Kit

For very experienced model builders.
Pre-cut wood chassis. Motor runs on two AA batteries (not included), which lie in a battery case. Gearbox runs on either normal or high speed. Grease included for lubrication of gears. Hex wrench and small phillips screws included. Pictorial instructions.
REQUIRES: Assembly. Small Phillips Screwdriver. Modeling Knife. Two AA Batteries
SPECS: Wood Chassis: Length: 6" (15.5cm) Width: 2-1/4" (5.9cm) Height: 1/4" (6mm)

TAMX1107 - $37.95

Line Tracing Snail Kit

For very experienced model builders.
The Line Tracing Snail uses a special LED sensor to detect a black line (magic marker, etc.) drawn on a white background. Uses two small Type FA-130 motors and rubber tires to slowly but surely move forward and turn. The body of the snail is made of transparent plastic to allow viewing of the intricate mechanisms inside. Photo transistor sensitivity can be adjusted to adapt for a variety of paper sizes and line widths. Snail eyes move in-synch with tires. Capable of low speed setting for fine lines and narrow areas or high speed setting for wide areas and thick lines. Pictorial assembly instructions.
REQUIRES: Assembly. Two AA Alkaline Batteries. Large Phillips Screwdriver. Hobby Knife. Long Nose Pliers. Black Magic Marker
SPECS: Total Height: 6.9" (17.6cm). Maximum Running Time: Low Speed-2 hours; High Speed-3 hours.

TAMX0152 - $39.95

Tracked Vehicle Chassis Kit

TAMX0108 - $19.95